Deer carving

This project is a deer carved in a dish with a forest background. The design is from Vectric Wild life DVD.
Material is African mahogany 15/16″ thick, 11 1/4″ wide by 16 3/4 high.

I V-Carved my name on the back using a 22 degree v-carve bit, the label is 4″ wide by 4″ high.
Roughing toolpath was done was a 1/4″ end mill – 150 ins/min machining time: 1 hours 25 minutes.
Finishing toolpath was done with 1/8″ taper ball nose – 150 ins/min machining time: 1 hours 50 minutes.
V-Carving 15 minutes

Total machine time was 3 hours 30 minutes.

The finish applied is 3 coats of Shellac